SensorCatalog

1/8 NPT thread dimensions

ASME B1.20.1 · Taper 1:16 · 60°

Dimensions

Major diameter
10.287 mm0.4050 in
Pitch
0.941 mm27 TPI
Thread height
0.753 mmbasic profile, before tolerances
Standard
ASME B1.20.1
Form
Taper 1:16
Flank angle
60°
Seals on
Thread + sealant
Used for
Process connections

For taper threads the diameter is the nominal pipe outside diameter used for identification; the thread diameter changes along the length at a taper of 1:16.

Check a measurement against this thread

Assembly and gauging

Hand-tight engagement L1
4.102 mm0.1615 in · about 4.5 turns by hand
Wrench make-up L3
2.822 mm0.1111 in · 3 threads: about 3 more turns with a wrench
Effective thread length L2
6.703 mm0.2639 in · external thread
Pitch diameter at hand-tight plane E1
9.489 mm0.3736 in
Pitch diameter at small end E0
9.233 mm0.3635 in

Basic dimensions from ASME B1.20.1. Male and female threads may each be up to one turn off basic, so the engagement you get varies by about ±1 turn per part; a joint that takes far fewer turns by hand points to a worn or wrong thread.

Thread profile

60°P 0.941 mm · 27 TPI

Schematic: flank angle and pitch-to-depth proportions to scale.

Easily confused with

ThreadStandardMajor diameterFlankSeals on
G 1/8ISO 228-1 (BSPP)0.56 mm smaller in diameter; pitch 0.907 mm55°Gasket / O-ring

Need a sensor with a specific process connection or thread adapter?

Contact us

↑ ↓ choose · Enter open · Esc close