SensorCatalog

1/4 NPT thread dimensions

ASME B1.20.1 · Taper 1:16 · 60°

Dimensions

Major diameter
13.716 mm0.5400 in
Pitch
1.411 mm18 TPI
Thread height
1.129 mmbasic profile, before tolerances
Standard
ASME B1.20.1
Form
Taper 1:16
Flank angle
60°
Seals on
Thread + sealant
Used for
Process connections

For taper threads the diameter is the nominal pipe outside diameter used for identification; the thread diameter changes along the length at a taper of 1:16.

Check a measurement against this thread

Assembly and gauging

Hand-tight engagement L1
5.786 mm0.2278 in · about 4 turns by hand
Wrench make-up L3
4.233 mm0.1667 in · 3 threads: about 3 more turns with a wrench
Effective thread length L2
10.206 mm0.4018 in · external thread
Pitch diameter at hand-tight plane E1
12.487 mm0.4916 in
Pitch diameter at small end E0
12.126 mm0.4774 in

Basic dimensions from ASME B1.20.1. Male and female threads may each be up to one turn off basic, so the engagement you get varies by about ±1 turn per part; a joint that takes far fewer turns by hand points to a worn or wrong thread.

Thread profile

60°P 1.411 mm · 18 TPI

Schematic: flank angle and pitch-to-depth proportions to scale.

Easily confused with

ThreadStandardMajor diameterFlankSeals on
9/16-18 UNFSAE J1926 (-6)0.57 mm larger in diameter; same pitch60°O-ring boss
PG 9DIN 404301.48 mm larger in diameter; pitch 1.410 mm80°Gland seal

Need a sensor with a specific process connection or thread adapter?

Contact us

↑ ↓ choose · Enter open · Esc close