SensorCatalog

1/2 NPT thread dimensions

ASME B1.20.1 · Taper 1:16 · 60°

Dimensions

Major diameter
21.336 mm0.8400 in
Pitch
1.814 mm14 TPI
Thread height
1.451 mmbasic profile, before tolerances
Standard
ASME B1.20.1
Form
Taper 1:16
Flank angle
60°
Seals on
Thread + sealant
Used for
Process connections and cable entries

For taper threads the diameter is the nominal pipe outside diameter used for identification; the thread diameter changes along the length at a taper of 1:16.

Check a measurement against this thread

Assembly and gauging

Hand-tight engagement L1
8.128 mm0.3200 in · about 4.5 turns by hand
Wrench make-up L3
5.443 mm0.2143 in · 3 threads: about 3 more turns with a wrench
Effective thread length L2
13.556 mm0.5337 in · external thread
Pitch diameter at hand-tight plane E1
19.772 mm0.7784 in
Pitch diameter at small end E0
19.264 mm0.7584 in

Basic dimensions from ASME B1.20.1. Male and female threads may each be up to one turn off basic, so the engagement you get varies by about ±1 turn per part; a joint that takes far fewer turns by hand points to a worn or wrong thread.

Thread profile

60°P 1.814 mm · 14 TPI

Schematic: flank angle and pitch-to-depth proportions to scale.

Easily confused with

ThreadStandardMajor diameterFlankSeals on
G 1/2ISO 228-1 (BSPP)0.38 mm smaller in diameter; same pitch55°Gasket / O-ring
R 1/2ISO 7-1 (BSPT)0.38 mm smaller in diameter; same pitch55°Thread + sealant

Need a sensor with a specific process connection or thread adapter?

Contact us

↑ ↓ choose · Enter open · Esc close